1. Do not wash the vehicle in the afternoon or evening, because the air is humid, so the water longer dry and iron resulted in rapid loss / corrosion.

2. At least once a month, give the lubricant on the door hinges, hood trunk, and hood. Clean the glass rubber and rubber corner of the glass. If necessary use of materials / special polish rubber.

3. Do check the engine oil before starting the engine. Replace the engine oil every 3000km.

4. Do a tune-up a minimum of 10,000 miles or 6 months.

5. Volkswagen treatment is recommended in a special workshop Volkswagen reputable or familiar.

6. Fill the tank before the fuel runs out to avoid the entry of dirt into the fuel filter.

7. Replace the fuel filter every tune-ups and a lot of dirt on the filter.

8. Replacement parts according to instructions from the mechanics.

9. There are no replacement parts are required on the machine.

Below the antique car care tips:

1. Check the overall condition of the engine, especially the ignition system.

2. Note the electrically conductive wires which over time will become brittle, causing the engine will not turn on.

3. Replace the piston ring is weakened by skyr valve. This is useful for smoothing the valve that has crusted up gas can flow smoothly.

4. Examine the car legs.

5. Protect your car with the car color cover.

6. Perform periodic maintenance of the entire car.

1. Leak Radiator

If the car is in motion, immediately stop the vehicle, if certain dry radiator water, wait until the engine is cold. After that pour the water in the radiator while observing the leak. Having known the leak patched with a banana. The way a banana split in half and shredded into the leaking section. Wait 10-15 minutes, and then fill the radiator. Just in case bring mixture patch radiator (radiator stop leak).

2. Long tie-rod bent

To straighten the pin and nut fastener opening tie-rod ends. Remove the steering knuckle arm. Usually because the old tie-rod untouched difficult removed. So knock of the arm knuckle with a hammer, knocking him from the top to avoid making the wide end of the threaded bolt. After removed, stepped on the bent tie-rod with the aid of another vehicle wheels, doing miraculous times up straight. Try to position the tie-rod across, not parallel with the tire.

3. The lights went out because the blown fuse

Park the car in a safe place. Remove the lamp terminals, take the cable to connect the negative terminal of the light located on the left of your front to the negative battery terminal. Just choose the other cable will be connected near the top or remote terminal on the right terminal directly connected to the battery plus terminal.

• Spark plugs, electronic fuel injection (EFI), coils, distributors, and platinum.
• Alternator, if submerged in water it can make a sound accompanied by the reduction of electric power. Even if the water mixed with mud, the engine may die suddenly.
• Air filters, if water enters through the carburetor and the engine was forced to live or walk, it can cause the piston bent or even broken. The same result can occur if water enters through the air intake.
• Air holes transmission, because this section can be passed water, it was likely mixed with transmission oil. As a result it may cause noise or at least result in loss or rusty gear.
• Braking system, it will not work perfectly because of the water. Note the rubber brake. To drum or disc system, which has been torn rubber can cause water to inundate parts of it, and caused the rust that eventually tie up the brake system as a whole.

1. Planning

Use the services of a proven reputation modifier, so you can devote the early draft of car you want and the designers this will surely provide useful input about colors, types, interior, etc.

2. Budget

Make sure how much funding will be allocated for the modification. Research in advance the price of spare parts and the time required for the modification, including fees for services modifier. As a precaution exaggerated budget 10%.

4. List of spare parts

After shopping, stacking the list of spare parts. Record anywhere goods are stored so as not to buy the same goods twice. Check if the spare is already embedded in the car.

5. Scrape off the paint

There are several methods; the most commonly used are blasting media which makes the car back to the original color of gray. Another method is to use soda blasting is to use baking soda in a high pressure which makes the car look clean, shiny (fresh from the factory). Or with acid dye, in which the car immersed in a pool full of acid to diminish the paint.

6. Paint

After the paint eroded, contact the shop or store famous painter often provide services. You can discussion for selection of brands and colors. Do not choose a cheap because the quality cannot be relied upon.

7. Brakes and suspension

Search engines can be coupled with a search for a suitable suspension system. Better to spend a lot of money for two things, it is guaranteed durable. Match all kinds and types of tires with brakes of your choice.

1. Clean the upholstery with a vacuum cleaner
2. Spray the detergent into a car seat
3. Brush your seat until the stains disappear
4. Drain by using a vacuum cleaner
5. Spray the car deodorizers
6. Use the seat cover to keep seat from stains

Although this paper a bit, I still hope I hope this article useful for you.

The first trimester:

1. Usually you have morning sickness. During the condition of the body is not fit, because these disorders nausea and vomiting, you better not drive by yourself.
2. The contents of the stomach before going. An empty stomach can trigger nausea.
3. Bring water and snacks for the “friends” trip.
4. If there is no food, you can suck candy ginger or lemon-flavored candy to relieve nausea.
5. Provide plastic bags to anticipate if you vomit.
6. If you drive by yourself suddenly want to vomit, dizziness, or other complaint, immediately set aside in a safe vehicle. If the condition is severe, call your husband or friend to help you.

Second trimester

If you do a long trip then:

1. Perform a complete inspection of the health condition of the womb and yourself
2. Stop several times about 10-15 minutes, especially if the spine and the back of the body start aching.
3. Come down from the car, a short walk and do stretching and other things that can make you relax.

Third trimester

1. In order not sore, prop your hips with a pillow
2. If sitting in the front seat, slide seat toward the back so your feet spacious.
3. Avoid the stress of traffic jams by listening to the radio or your favorite song.

1. Preparation

Prepare vehicle for night travel. Besides ascertained headlights and rear lights turn on with normal and clean. The entire outside and inside the glass must also be clean.

2. Turn on high beam

If you doubt there is “something” in front, turn on high beam. Distant lights help you see clearly and make other motorists know that there are vehicles that you drive.

3. Slow down and keep your distance

Reduce speed and add distance to the car in front or behind. At night is more difficult to measure the distance of other cars.

4. Stop in a safe place

Make sure you can stop in the area illuminated by the headlights of your own. If not, you will not be time to put the brakes if something had suddenly appeared.

5. Switch the view to the left side

If the vehicle from the front of the dazzling lights, do not look forward but look to the left side of the road to guide the direction. This is to avoid the light blinded you.

Here are some tips:

1. Signs of damage

Normally each crash there will be signs in advance except in case of deviant cases, such as an accident. Then see if the symptoms are not normal. This attitude will help and make it easy to detect more early damage.

2. Observe damage

If there is damage to the machine then the improvement should not be delayed much longer. But remember, if you do not have the skills, do not occasionally dismantle and repair alone. In addition to just waste time and energy, the damage may be worse. Better you take it to a repair shop immediately.

3. Streak damage

If your motorcycle hit a row of symptoms and more than one cause, then check the parts that are easily accomplished beforehand and then one by one into the other parts.

1. Ensuring Safety (Safety First)

You will definitely bring your children to travel together, and do not forget the equipment they have, such as toys, bags, and so forth. So safety is always priority, although every car is equipped with safety standards that exist.

2. Test Drive or Safety Test

Do a test drive before buying a car, either a new car or second car, make sure everything is functioning properly, starting from the interior, engine, steering, and other car parts. It is better to ask about our safety test at a car dealership in question, whether already passed the safety test or not.

3. Safety air bags

The car with the air bag has started production since 1998 and usually there are air pockets in the front of the car. Although the air bag is working to save the passengers (according to the survey, air bag may reduce the risk of accidents by 30% in adults), but can also injure children.

4. Seat belt

Should install seatbelts in every seat, both front seats, middle and rear seats. Make sure that you plug the seat belt can be adjusted also for children’s sizes.

5. Anti-lock brakes

The brake system will generally lock / brakes on a slippery road and can cause car slipped. Today, however, can be equipped with ABS system (Anti-lock Braking System), which can be locked when the car skidded and the car remains in a state controlled.

6. Safety Door and Window Locks

Make sure the car is equipped with Safety Door and Window Locks so you can ensure children are always safe in the car at all times.